A blog about finding and keeping my 1973 Mustang Grande (V8 - 351C 2V). Produced on July 6, 1973. Sold in Florida, USA.

Saturday, February 21, 2015

Replacing the filler cap

One thing that's been on my wish list for a long time, is to replace this old filler cap. The plastic glass is so cracked that you can hardly see the horse, which is a shame of course.

One of my birthday gifts from friends and family was this new filler cap. Looks a lot better don't you think?

Yes, it does! :-)

I looked around a bit more and noticed this little thing that sits at the bottom of the engine, I think just on top of the crank. What is it?

And in the electrical department I found this loose connector. it looked like it had been in use once. What was it for? Hmm...

And finally I noticed my seat is loose and the discovered that this nut isn't fixed all the way. However, when I try to fasten it, the whole thing spins along. I looked underneath the car to see if I could keep it from moving there but I couldn't see anything. To be continued...

No comments:

Post a Comment